Is it possible to remap the apc40?

Need help with Midiflow? Ask here!
Post Reply
DustyATX
Posts: 1
Joined: Fri May 24, 2019 11:42 am

Is it possible to remap the apc40?

Post by DustyATX » Fri May 24, 2019 12:00 pm

Hi everyone

I have an APC40 controller that I'd love to use with gadget. The issue is through out the controller it send messages on different channels. For example the top knob bank sends CC 71-79 messages on channel 0 and the knob bank below sends CC 71-79 USING channel 8. The Tigger pads send note on/off but each column uses a different channel 0-7. So column 1 position 1 is midi 0 note 53, column 2 position 1 is midi 1 note 53, column 3 position 1 is midi 2 note 43.

So my question is. Is it possible to remap channel & event data. Ultimately I want all events sent via midi channel 1. So for the Tigger pads, column 1 position 1 is midi 1 note 53, column 2 position 1 is note 54 , column 3 position 1 is note 55.

If midiflow can't do this any suggestions for software that will?

Thanks a ton
Dusty

User avatar
Johannes
Site Admin
Posts: 82
Joined: Mon Mar 25, 2019 3:06 pm

Re: Is it possible to remap the apc40?

Post by Johannes » Mon Jul 15, 2019 12:59 pm

Yes, you can have different routings that listen of different channels. All routings could then remap to the same channel. https://www.midiflow.com/documentation/ ... -remapping

Best,
Johannes

Post Reply