When I tried remapping All channel or a specific channel to 16 it result to channel 1. Or when i remap it to channel 16 results to channel 1.
Scenario:
#I was doing a controller remap Incoming message CC52 to a specific Sysex command on the hardware synth. So I can change whatever CC52 incoming message to something.
#Restrict Channel to 16 & Remap Channel to 16 thus results to 15 as output result. So It triggers Ch.15 and not 16.
#So what I did is to remap Ch.16 to Ch.1 which it says correct 16 as a channel when I set it to 1.
Ch 1 = Ch16
#Also Sysex output isn't right as it should be on the channel.
Any update on this?