Hi everyone
I have an APC40 controller that I'd love to use with gadget. The issue is through out the controller it send messages on different channels. For example the top knob bank sends CC 71-79 messages on channel 0 and the knob bank below sends CC 71-79 USING channel 8. The Tigger pads send note on/off but each column uses a different channel 0-7. So column 1 position 1 is midi 0 note 53, column 2 position 1 is midi 1 note 53, column 3 position 1 is midi 2 note 43.
So my question is. Is it possible to remap channel & event data. Ultimately I want all events sent via midi channel 1. So for the Tigger pads, column 1 position 1 is midi 1 note 53, column 2 position 1 is note 54 , column 3 position 1 is note 55.
If midiflow can't do this any suggestions for software that will?
Thanks a ton
Dusty
Is it possible to remap the apc40? Topic is solved
Re: Is it possible to remap the apc40?Accepted answer
Yes, you can have different routings that listen of different channels. All routings could then remap to the same channel. https://www.midiflow.com/documentation/ ... -remapping
Best,
Johannes
Best,
Johannes