Page 1 of 1

CC not mapping correctly

Posted: Sat Jan 11, 2020 9:06 pm
by richmois
I'm using the following harware:

Headrush Looperboard
iRig Blueboard (bluetooth)
BM-A01 (midi bluetooth)

I'm trying to control my looper , using Blueboard and BM-A01 being plugged to the looper.
It is difficult to configure, and I have only been successfull in mapping the Blueboard switch A (cc20) to the looper "start/stop all" button.

When I try to map other Blueboard buttons , Midiflow seems to send the same cc messages to the BM-A01, even if the set-up is different.

I attached screen captures showing that CC20 is correctly mapped to CC000, but CC21 is mapped to CC000 instead of CC012 as it should.

Can you help me?

Re: CC not mapping correctly

Posted: Sun Jan 12, 2020 9:49 am
by Johannes
Hi
Please select "MSB" (instead of "MSB+LSB") for the outgoing controller.

Best,
Johannes

Re: CC not mapping correctly

Posted: Sun Jan 12, 2020 8:31 pm
by richmois
Hi,

When I select MSB, and CC12 mapped to CC21, the resulting CC are 000 and 127, instead of CC12.

If MSB+LSB is not selected, with CC3, then the Looperboard has no reaction to CC messages.

The lopperboard manual shows:
MIDI Control: Footswitch Actions (CC#3)
All actions on this page are triggered by sending the listed Data Messages using MIDI CC#3
messages. (See attachment)

Thanks

Richard