Note Value to CC: Linear Mapping shows strange Behavior.
Posted: Wed Nov 20, 2019 2:03 pm
HiFolks,
I am not sure whether I am dump or there is a Bug in the Note to CC feature.
Here is what I need:
I need the Notes C#5, D5, D#5 and E5 to be translated into CC10 with the values 0,1,2 and 3 and the notes F2, F#2, G2 and G#2 to the CC10 values 7, 8, 9 and 10. Sounds easy.
Here is what I tried:
I started, setting up one Controller: Note value to CC with the Input Range from C#5 to E5 and an output range 0 to 3. As expected, it works: These four notes will be converted to the values 0,1,2 and 3. But unfortunately the notes F2 to G#2 are matched to 0, because they are out of range.
So I converted it to a LIST. For the selected notes C#5 to E5 the list shows the values 0—3 and a 0 for all under and 3 for all above. Up to here everything as expected.
But now the strange behavior: From now on the tool is translating the notes to CC values as follows:
C#5 (CC10: 0), D5 (CC10:129 ), D#5 (CC10:2) and G#5 goes to CC10 value 131.
Why 129 and 131 instead of 1 and 3?
But it comes even stranger. If I put for the notes F2 to G#2 the values 7 to 10 the result are translations to the CC10 values 135, 08, 137 and 10.
So every second note is translated to a value above 127. Is it a bug or what do I wrong? Thanks for your support.
I am not sure whether I am dump or there is a Bug in the Note to CC feature.
Here is what I need:
I need the Notes C#5, D5, D#5 and E5 to be translated into CC10 with the values 0,1,2 and 3 and the notes F2, F#2, G2 and G#2 to the CC10 values 7, 8, 9 and 10. Sounds easy.
Here is what I tried:
I started, setting up one Controller: Note value to CC with the Input Range from C#5 to E5 and an output range 0 to 3. As expected, it works: These four notes will be converted to the values 0,1,2 and 3. But unfortunately the notes F2 to G#2 are matched to 0, because they are out of range.
So I converted it to a LIST. For the selected notes C#5 to E5 the list shows the values 0—3 and a 0 for all under and 3 for all above. Up to here everything as expected.
But now the strange behavior: From now on the tool is translating the notes to CC values as follows:
C#5 (CC10: 0), D5 (CC10:129 ), D#5 (CC10:2) and G#5 goes to CC10 value 131.
Why 129 and 131 instead of 1 and 3?
But it comes even stranger. If I put for the notes F2 to G#2 the values 7 to 10 the result are translations to the CC10 values 135, 08, 137 and 10.
So every second note is translated to a value above 127. Is it a bug or what do I wrong? Thanks for your support.